| Yubico Forum https://forum.yubico.com/ |
|
| Configure Button Disabled https://forum.yubico.com/viewtopic.php?f=23&t=796 |
Page 1 of 1 |
| Author: | Kevin [ Tue May 08, 2012 1:33 am ] |
| Post subject: | Configure Button Disabled |
Attempted to configure my yubikey on a VM Windows 7 Pro (Build 7601, SP1) from the YubiKey Logon Administration window but the Configure button was disabled. Afterwards restarted machine but Configure button continued disabled. Finally removed YubiKey Logon installation. |
|
| Author: | Klas [ Tue May 08, 2012 6:33 am ] |
| Post subject: | Re: Configure Button Disabled |
Hello, When using in a virtual machine, make sure you map the raw usb device through to the VM, that way the configure button should be enabled for you. If this does not work, what virtualisation software are you running, and on what host OS? /klas |
|
| Author: | Kevin [ Wed May 09, 2012 2:11 am ] |
| Post subject: | Re: Configure Button Disabled |
99% sure the VM has been configured to work with the host machine USB port because I can successfully use the Yubico Demo server. I again attempted to configure Yubikey Logon but the Configure button is still disabled. VM = VMware Workstation, 8.0.3 build-703057 Host = Windows 2003 R2, SP2 |
|
| Author: | Klas [ Wed May 09, 2012 6:52 am ] |
| Post subject: | Re: Configure Button Disabled |
The only virtualization (that I know of) that it's tested with is virtual box, so it might be that information is lost when using with vmware, but it should be possible to get it to work, though I have little to no experience with it. That OTP generation works is unfourtunately not an indicator that it's mapped through as that's usually sseen as coming from the virtual keyboard connected to the VM. If the YubiKey is mapped through properly there will be a second "HID Keyboard Device" in the device manager, to verify that it is the YubiKey you can open it and check the Hardware Ids under details. The YubiKey has a VID of 1050 and a PID of 0010. /klas |
|
| Author: | Kevin [ Thu May 10, 2012 2:27 am ] |
| Post subject: | Re: Configure Button Disabled |
Here's my final response. Yes the Yubikey was not enabled. On VMWare Workstation Yubikey is enabled once the VM is active where there's a series on device icons at the lower right corner of the VM Window but since I always use the VM in full screen mode those icons were not visible. The tooltip for the Yubikey icon reads as follows, "Yubico Yubikey II". Able to install the Yubikey Logon software and configure the Yubikey with a good "Test" response. After restarting the machine I did see under the logon box the statement that Yubikey was enabled for logon. However the logon failed for my Yubikey challenge but suceeded with my system password. I configured my Yubikey to not have “button press” configured for challenge-response. |
|
| Author: | Kevin [ Thu May 17, 2012 1:39 am ] |
| Post subject: | Re: Configure Button Disabled |
Reinstalled Yubikey Logon with success. Once I understood that Yubikey augments the Windows password and does not replace it then I was able to use it as designed. FYI: My ultimate goal would be to replace password with Yubikey. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|