| Yubico Forum https://forum.yubico.com/ |
|
| Interfacing Yubikey 4 Nano with OpenSC https://forum.yubico.com/viewtopic.php?f=35&t=2675 |
Page 1 of 1 |
| Author: | bmomjian [ Thu Jul 20, 2017 10:17 pm ] |
| Post subject: | Interfacing Yubikey 4 Nano with OpenSC |
I am able to use the yubico-piv-tool tool to set my pin, etc, and I am able to use OpenSC to see the Yubikey Nano device and mechanisms. However, I can't figure out how to interface to the slots, e.g. 9a, 9c. How do I do that? I have found documentation on how to get existing software to interface to the Yubikey Nano, but no documentation on how to get the OpenSC command-line tools like p11-tool or pkcs11-tool to operate on the slots, or even to list the slots. Thanks. |
|
| Author: | bmomjian [ Thu Jul 20, 2017 10:23 pm ] |
| Post subject: | Re: Interfacing Yubikey 4 Nano with OpenSC |
Oh, I would also like to know how to access the slots via OpenSSL too. Thanks. |
|
| Author: | bmomjian [ Wed Aug 16, 2017 2:20 pm ] |
| Post subject: | Re: Interfacing Yubikey 4 Nano with OpenSC |
I figured it out. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|