Yubico Forum
https://forum.yubico.com/

[QUESTION]Program multiple Yubikeys in challenge-response
https://forum.yubico.com/viewtopic.php?f=30&t=2282		 Page 1 of 1
Author:  jonf [ Thu Apr 14, 2016 1:32 pm ]
Post subject:  [QUESTION]Program multiple Yubikeys in challenge-response
Hi,

I've been trying to configure my Yubikeys in challenge-response mode as per Yubico's instructions for enabling Yubikey Logon for Windows. I have setup the Personalisation Tool as per the attached screenshot (secret key displayed for reference only, not in use), and I have the following Yubikeys:

2x Yubikey standard models - one with firmware 2.2.1 and the other with 2.4.1
2x Yubikey NEO models - one with 3.1.2 and the other with 3.4.9 (purchased yesterday)
2x Yubikey 4 models - both with 4.2.8 (both also purchased yesterday)

One thing I noticed is if I then run the challenge-response tester in the Personalisation Tool I seem to get the same response from only 4 of the 6 keys above despite my settings. The two Yubikey 4 models give a different response from the others.

Is this normal or is there something I'm missing?

Attachments:
yubikey-pt-1.png
yubikey-pt-1.png [ 48.39 KiB | Viewed 2217 times ]
Author:  ChrisHalos [ Thu Apr 14, 2016 4:30 pm ]
Post subject:  Re: [QUESTION]Program multiple Yubikeys in challenge-respons
If the Challenge presented is 0 bytes, the NEO/Standard will respond differently than the 4/Edge. Basically, put nothing into the "Input challenge" field in the Challenge-Response Tester and you will get different results. Enter even a single character into the "Input challenge" field and the response will be the same for all models.
Author:  jonf [ Thu Apr 14, 2016 4:38 pm ]
Post subject:  Re: [QUESTION]Program multiple Yubikeys in challenge-respons
ChrisHalos wrote:
If the Challenge presented is 0 bytes, the NEO/Standard will respond differently than the 4/Edge. Basically, put nothing into the "Input challenge" field in the Challenge-Response Tester and you will get different results. Enter even a single character into the "Input challenge" field and the response will be the same for all models.


OK that explains it. I just tried them all again after entering "1" into the input challenge field and now they all have the same response.

Thanks for replying. :)
Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/