Yubico Forum https://forum.yubico.com/ |
|
Implementing GPG in Yubikey NEO https://forum.yubico.com/viewtopic.php?f=26&t=1000 |
Page 3 of 3 |
Author: | mezinster [ Mon Dec 28, 2015 8:34 pm ] |
Post subject: | Re: Implementing GPG in Yubikey NEO |
bober wrote: Hi, I just had the same problem with a build-in smartcard reader. The approach of Klas was right. But you have to add this line to your scdaemon.conf: Code: reader-port Yubico Yubikey NEO OTP+CCID 0 That's the name scdaemon recognizes the Yubikey with the corresponding Port "0". Regards, bober That's a solution i was looking for YEARS! I suppose it's worth to be added to Yubikey FAQ , really! |
Author: | brunov [ Wed Nov 30, 2016 8:14 pm ] |
Post subject: | Re: Implementing GPG in Yubikey NEO |
bober wrote: Hi, I just had the same problem with a build-in smartcard reader. The approach of Klas was right. But you have to add this line to your scdaemon.conf: Code: reader-port Yubico Yubikey NEO OTP+CCID 0 That's the name scdaemon recognizes the Yubikey with the corresponding Port "0". Regards, bober I followed these steps and I am still unable to get gpg to read the card. The only difference that I know of is that mine has connection modes OTP+U2F+CCID so I made that change in the scdaemon.conf and still was not able to get it to work. |
Author: | brunov [ Thu Dec 01, 2016 6:51 pm ] |
Post subject: | Re: Implementing GPG in Yubikey NEO |
brunov wrote: bober wrote: Hi, I just had the same problem with a build-in smartcard reader. The approach of Klas was right. But you have to add this line to your scdaemon.conf: Code: reader-port Yubico Yubikey NEO OTP+CCID 0 That's the name scdaemon recognizes the Yubikey with the corresponding Port "0". Regards, bober I followed these steps and I am still unable to get gpg to read the card. The only difference that I know of is that mine has connection modes OTP+U2F+CCID so I made that change in the scdaemon.conf and still was not able to get it to work. So for a moment it was able to read the card after writing my last message but it could not write new information to the card. When I went through the steps earlier I was unable to read the card again. Also I have another smartcard client installed and running. Would that also give the scdaemon problems? |
Page 3 of 3 | All times are UTC + 1 hour |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |