| Yubico Forum https://forum.yubico.com/ |
|
| [BUG] ykpersonalize does not use access code with -m https://forum.yubico.com/viewtopic.php?f=26&t=993 |
Page 1 of 1 |
| Author: | danfuhry [ Thu Mar 07, 2013 6:33 pm ] |
| Post subject: | [BUG] ykpersonalize does not use access code with -m |
When setting mode on my NEO. Firmware 3.0.4. Command line: ykpersonalize -m82 -y Arch Linux, latest packages. ykpersonalize reports "Firmware version 3.0.4 Touch level 1541 Program sequence 1." I have tried the release version of ykpersonalize as well as the latest code from git. strace output after the confirmation prompt |
|
| Author: | danfuhry [ Sun Mar 10, 2013 9:34 pm ] |
| Post subject: | Re: [QUESTION/BUG] "Yubikey core error: write error" |
I was able to program it by unsetting the programming passcode. Note that ykpersonalize did not use the access code I provided it, even though it was correct. So, this is a bug in ykpersonalize which does not use the access code provided when changing the mode. -Dan |
|
| Author: | Klas [ Mon Mar 11, 2013 1:23 pm ] |
| Post subject: | Re: [BUG] ykpersonalize does not use access code with -m |
Hello. This is a limitation in the YubiKey NEO, the mode flags and the scanmap cannot be changed if either slot is protected by an accesscode. /klas |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|