Yubico Forum

Dear Yubico tech community,

I am just starting with the YubiRadius, the first users can already authenticate, but there is still an issue:

The users were imported successfully, using e.g. following filter:
(|(memberOf=cn=SEC-GL-ABC-VPN,ou=SecurityGroups,ou=SEC,dc=example,dc=com)(memberOf=cn=SEC-GL-VWX-VPN,ou=SecurityGroups,ou=SEC,dc=example,dc=com))

So I can see the users, when I click on "Users/Groups".
When I click on "Groups" there are a bunch of groups, so I want to change the priority to allow passing the right fgroup informastion to the Cisco ASA.
The group "SEC-GL-ABC-VPN" is showing up, so I can increate the priority to a higher value than 0, but "SEC-GL-VWX-VPN" is not showing up.

I thought importing users out of a group will automatically list the group there?!

Additional information:
- there are 374 groups listed (perhaps a limit?)
- some groups are displaying multiple times (like e.g. "SecurityGroups"), is this normal?

Thank you!

Dear StefanR

YubiRadius is a discontinued project. You may want to checkout YubiX

https://github.com/Yubico/yubix

http://www.yubico.com/2013/11/yubix-ref ... are-stack/

_________________
-Tom