Yubico Forum

...visit our web-store at store.yubico.com
It is currently Wed Oct 18, 2017 1:15 am

All times are UTC + 1 hour




Post new topic Reply to topic  [ 3 posts ] 
Author Message
PostPosted: Thu Apr 14, 2016 1:32 pm 
Offline

Joined: Fri Jul 15, 2011 7:35 pm
Posts: 2
Hi,

I've been trying to configure my Yubikeys in challenge-response mode as per Yubico's instructions for enabling Yubikey Logon for Windows. I have setup the Personalisation Tool as per the attached screenshot (secret key displayed for reference only, not in use), and I have the following Yubikeys:

2x Yubikey standard models - one with firmware 2.2.1 and the other with 2.4.1
2x Yubikey NEO models - one with 3.1.2 and the other with 3.4.9 (purchased yesterday)
2x Yubikey 4 models - both with 4.2.8 (both also purchased yesterday)

One thing I noticed is if I then run the challenge-response tester in the Personalisation Tool I seem to get the same response from only 4 of the 6 keys above despite my settings. The two Yubikey 4 models give a different response from the others.

Is this normal or is there something I'm missing?


Attachments:
yubikey-pt-1.png
yubikey-pt-1.png [ 48.39 KiB | Viewed 1652 times ]
Top
 Profile  
Reply with quote  

Share On:

Share on Facebook FacebookShare on Twitter TwitterShare on Tumblr TumblrShare on Google+ Google+

PostPosted: Thu Apr 14, 2016 4:30 pm 
Offline
Yubico Team
Yubico Team

Joined: Thu Oct 16, 2014 3:44 pm
Posts: 308
If the Challenge presented is 0 bytes, the NEO/Standard will respond differently than the 4/Edge. Basically, put nothing into the "Input challenge" field in the Challenge-Response Tester and you will get different results. Enter even a single character into the "Input challenge" field and the response will be the same for all models.


Top
 Profile  
Reply with quote  
PostPosted: Thu Apr 14, 2016 4:38 pm 
Offline

Joined: Fri Jul 15, 2011 7:35 pm
Posts: 2
ChrisHalos wrote:
If the Challenge presented is 0 bytes, the NEO/Standard will respond differently than the 4/Edge. Basically, put nothing into the "Input challenge" field in the Challenge-Response Tester and you will get different results. Enter even a single character into the "Input challenge" field and the response will be the same for all models.


OK that explains it. I just tried them all again after entering "1" into the input challenge field and now they all have the same response.

Thanks for replying. :)


Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC + 1 hour


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group