Welcome to Yubico tech community.

Hi Everyone,

I am wanting to use my yubikey in Static Password mode, but I don't want it to issue a return (enter) at the end of the static password. How can I remove this?

I have Personalisation tool 3.0.2 and firmware version 2.2.3

Any help would be much appreciated.

Thanks,
Gary

Hello,

Under the Settings tab, depress the "Enter" button under output format.

/klas

Thanks for your answer. I have tried this but it doesn't do anything.

Hello,

After you depress the enter you have to hit save at the bottom of the settings screen, and then reprogram the YubiKey with static password. I missed that save button myself when testing this a moment ago, quite hard to see and remember.

/klas

YEY thanks klas. It works now.

I wasn't missing the save button. I didn't realise you had to re-programme the static password after you click send. Works fine now!

Perhaps this would be a good little note to put in the next version of the personalisation tool as its not exactly obvious.


Thanks again

Yay, great!

My problem was missing the save button when I tried it.. I agree that it's not obvious how to get it right, we'll have to consider how to make it better.

/klas